The Seymour Duncan TS-2 makes wiring mods easy with four different sounds at tips of your fingers. This is a set of arched neck and bridge trim rings, designed for Les Paul and similar guitars with arched tops. See the specs below for dimensions.
The Seymour Duncan TS-2 SET includes one TS-2n (Neck) and one TS-2b (Bridge) mounting rings for Les Paul Humbuckers. The TS-2 SET allows you to expand your tonal palette by accessing three unique tones from a humbucker, thanks to the TS-2 mounting ring that holds two small switches. For use with nearly any humbucker pickups with four-conductor cable on Les Paul guitars, Seymour Duncan or otherwise.
This "stealth" pickup switching device allows you to access series, parallel and split wirings with a standard humbucker. And it's easy to install. Just solder your pickup leads to a small color-coded circuit board. That's it. Push the two switches towards each other for standard series wiring; away from each other for parallel wiring; and both towards one coil (either one) to shut that coil off.
Specifications
TS-2N (Neck) Inside: 2.780 x 1.470 inches Outside: 3.54 x 1.78 inches Pickup mounting hole spacing: 3.076 inches on center Trim ring mounting hole spacing: 3.20 x 1.513 inches on center Height: 0.200 inches (ring), 0.328 inches (switch casing) Circuit board: 1.353 x 0.402 inches Soundboard radius: 43.5 TS-2b (Bridge) Inside: 2.780 x 1.470 inches Outside: 3.54 x 1.78 inches Pickup mounting hole spacing: 3.076 inches on center Trim ring mounting hole spacing: 3.20 x 1.513 inches on center Height: 0.426 inches (ring), 0.554 inches (switch casing) Circuit board: 1.353 x 0.402 inches Soundboard radius: 20.4
Note: Will not fit Nickel and Gold covered Trembuckers.